D) Adjusting The Servo Throw - Reely SKY 20 70 77 Bedienungsanleitung

d) Adjusting the servo throw

The receiver/control unit (1) allows you to influence the
throw of the nick and roll servos. The adjustment control
(2) for the servo throw is on the left side of the receiver/
control unit.
If you turn the adjustment control (2) to the right using the
included screw driver, servo throw increases and the model
responds to nick and roll commands more vigorously.
Turn the control to the left to reduce servo throw to cause
the model to respond to nick and roll commands less
vigorously.
Please note:
The control is preset in the optimal position. You should not make any changes if you are comfortable
with the control response of the model.
The short wire on the receiver/control unit (see ill. 20, pos. 3) serves as the receiving aerial. It should be
stowed in the canopy as straight as possible. The wire must not be shortened or coiled up!
Figure 20
61