Other Functions; List Of Functions; Adjusting The Input Gain; Adjusting The Output Gain - Roland SP-404SX Bedienungsanleitung

Other Functions

List of Functions

You can access the following functions by holding down the [FUNC] button and pressing the corresponding pad.
For details on each function, refer to the page listed in the table below.
Pad Function
TAP TEMPO PAUSE
1 COPY
2 EXCHANGE
3 IMPORT
4 AUTO TRIG LEVEL
5 BACKUP LOAD
6 BACKUP SAVE
7 ILLUMINATION
8 EFFECT LIMIT
9 MIDI CH
10 MIDI SYNC
11 INPUT GAIN
12 OUTPUT GAIN

Adjusting the Input Gain

Here's how to adjust the SP-404SX's input gain.
MEMO
If the PEAK indicator stays lit and it's not possible to
adjust the volume of your audio source device, set the
SP-404SX's input gain to "-10 dB. "
1. Hold down the [FUNC] button and press the pad
[11] (INPUT GAIN) .
2. Turn the [CTRL 3] (LEVEL) knob to make the
setting .
The [REC] button will blink when you turn the knob.
Range: -10 dB, 0 dB
3. Press the [REC] button to confirm the setting .
MEMO
• If you decide to cancel, press the [CANCEL] button.
• This setting is retained even while the power is turned
off.
LINE IN jacks Input Gain
[MIC IN]
MIC IN jack
knob
Description
Stops all sound
Copies a sample or pattern
Exchanges the patterns or samples of pads
Imports WAV/AIFF files from the SD card
Adjusts the trigger level for auto sampling
Loads backup data
Saves backup data
Display illumination and sleep settings
Used to make settings for Effect Limit mode
Changes the MIDI channel
Synchronization with an external MIDI device
Adjusts the input gain
Adjusts the output gain

Adjusting the Output Gain

Here's how to adjust the overall volume of the SP-404SX.
MEMO
1. Hold down the [FUNC] button and press the pad
[12] (OUTPUT GAIN) .
2. Turn the [CTRL 3] (LEVEL) knob to adjust the
setting .
The [REC] button will blink when you turn the knob.
Range: -3 dB, 0 dB, 3 dB, 6 dB, 9 dB, 12 dB
PEAK
indicator 3. Press the [REC] button to confirm the setting .
MEMO
The SP-404SX has a maximum polyphony of twelve
notes. There will be a major difference in the volume
depending on whether one note or twelve notes are
being produced. If you are playing only a few pads at
a time, or if you have connected the SP-404SX to a DJ
mixer or other device, and are using it as an effects
processor, raising this internal processing level will
allow you to output a higher level. If you are playing a
larger number of pads simultaneously and the sound
is distorting, you should lower this internal processing
level.
• If you decide to cancel, press the [CANCEL] button.
• This setting is retained even while the power is turned
off.
Page
p . 12
p . 31, p . 34
p . 31, p . 34
p . 36
p . 25
p . 37
p . 37
p . 40
p . 42
p . 47
p . 47
p . 39
p . 39
39