Signal Strength; Zoom Mode (Qvga) - Conrad 75 17 47 Bedienungsanleitung

• When pairing is successful, the camera feed is displayed on the desired channel and the LINK LEDs
(4, 14) on light up.
If pairing is unsuccessful, the receiver/camera might be out of range. Move the cam-
era closer to the receiver.

8.3 Signal strength

An aerial symbol is displayed in the top left-hand corner of the screen. Four vertical bars are displayed
next to the aerial symbol. They indicate the signal strength (max. 4 bars = best reception quality).
Signal Number of
displayed
Lines
Optimal 4
Good 3
Normal 2
Poor 1
No signal 0
* VGA image frequency is used in normal display mode.
** QVGA image frequency is used in zoom mode (see chapter "6.4 Zoom mode").

8.4 Zoom mode (QVGA)

Press the button "Zoom ON/OFF"
"ZOOM" is displayed to indicate it.
If you are not in zoom mode, you are in normal display mode (VGA).
In zoom mode, you can move the camera image up, down, left, or right. Use the navigation keys to make
a selection
Data rate
in Kbps
1062 ~ 1280
725 ~ 1062
543 ~ 725
250 ~ 543
0 ~ 250
to enter or exit zoom mode (QVGA). When zoom mode is active,
.
VGA * Frame rate
(frames per second)
5 ~ 10
3 ~ 5
2 ~ 4
0 ~ 1
0
QVGA **frame rate
(frames per second)
15 ~ 30
12 ~ 20
8 ~ 15
0 ~ 4
0
43