Snooze Function; Temperature Alarm; S) Illumination - Conrad 64 61 09 Bedienungsanleitung

Snooze function

When the alarm sounds at the set time, you can activate the snooze by briefly pressing the "SNOOZE/
LIGHT" button
This interrupts the alarm for about 8 minutes before it starts again.
Now you can reactivate the snooze function again, if you still don't want to get up.
If the alarm is not stopped within 2 minutes by briefly pressing the "ALARM" button, the
snooze function is automatically activated. This happens three times in succession, then
the alarm stops.
r) Temperature alarm
You can set an upper and a lower limit for the temperature, from which on a tone signal is emitted.
The temperature alarm is only emitted if the temperature is either below or above the set
level at an outdoor sensor (not at base station).
If a tone signal is emitted at a temperature alarm, this can be stopped by briefly pressing the "TEMP
ALARM" button.
To set an upper or lower limit for the temperature, proceed as follows:
• Press the "TEMP ALARM" button to switch between the display of the upper limit, the lower limit
and the normal display.
• If the upper or lower limit is displayed, you can change it. To do this, hold the "TEMP ALARM"
button down (approx. 2 seconds) until the displayed reading flashes.
• Set the temperature limit with the "+" and "-" buttons.
• Confirm the setting by briefly pressing the "TEMP ALARM" button.

s) Illumination

Briefly pressing the "SNOOZE • LIGHT" button on top of the base station activates the built-in
background illumination of the LC display for a couple of seconds.
75