Turning The Pre-Alarm On/Off; Stopping The Alarm Signal; Snooze Function ("Snooze") - Conrad TE827NL Bedienungsanleitung

All manuals and user guides at all-guides.com
 Turning the pre-alarm on/off, setting the pre-alarm
• First activate an alarm function as described above (either "
• Then select the pre-alarm; briefly and repeatedly press the button "ALARM/CHART" until the display shows
"PRE-AL".
• Activate/deactivate the pre-alarm with the button " " (6) or " " (7). With a deactivated pre-alarm, the display
shows "OFF", with activated pre-alarm a time period of 15, 30, 45, 60 or 90 minutes).
• Now keep the button "ALARM/CHART" (1) depressed until the displayed period (15, 30, 45, 60 or 90) blinks. Set
the minutes for the pre-alarm with the button " " (6) or " " (7) and confirm your setting by briefly pressing the
button "SET" (5).

Only a time period of 15, 30, 45, 60 or 90 minutes can be set.
 Stopping the alarm signal
• Once the alarm signal sounds at the set time, you can turn it off by pressing the button "ALARM/CHART" (1).
• You can also activate a snooze function ("SNOOZE"), see next section.
 Snooze function ("SNOOZE")
Once the alarm function sounds at the set time, you can activate the snooze function with a brief press of the button
"SNOOZE" (8) on the top of the weather station.
This interrupts the alarm signal for a certain time and then starts it again.
You can activate the snooze function once again if you do not want to get up yet.

If an alarm signal is not deactivated within 2 minutes by briefly pressing the button "ALARM/CHART",
the snooze function is activated automatically. This takes place three times; afterwards, the alarm
function is deactivated.
When programming an alarm time, you can set how long the alarm signal is supposed to be interrupted
(1 to 15 minutes), see the chapter "Setting the alarm time".
80
W" or " S").