Boiler Activation; Time Programme Setting - Gorenje Ecologic 23 Bedienungs, Wartungs Und Montageanleitungen

11.3 BOILER ACTIVATION

When pressing and holding the ON/OFF button for more than half a second (boiler at standstill), the
display shows OFF, and the boiler begins activation sequence once the button is release. Display
indicates TESTFIRE. Fans operate at high speed to clean the firebox. Dosing screw is at standstill,
spark plug is heating.
If the firebox temperature is low, sequence
stand still. Then sequences
transition to burning phase (BURN).

11.4 TIME PROGRAMME SETTING

Press and hold (until TEN displays) MENU button to access time programme menu. You can select a
setting with a press of the MENU button. Adjust the selected setting with the UP/DOWN arrows and
confirm it with the MENU button.
By setting the timer ON or OFF, the timer activates or deactivates.
Before activation of the timer menu, accurate time and day of the week (1 is Monday etc.) must be set.
Then you can programme 6 periods and temperatures.
Each of 6 time period is determined by start (P1a – programme 1 start time) and end time (P1d –
programme 1 end time). In this period, the boiler is active and operates by maintaining water
temperature in the boiler (P1t).
Then select up to 3 time periods for each day of the week.
Example (Tuesday): upper display shows DAY2, and lower t1P1, t2P3 and t3P6, which means that
the boiler will be active on Tuesday in periods, programmed with programmes P1, P3 and P6.
DAY1
24
18
12
.
.
.
.
.
.
DAY7
24
18
12
HEAT UP
Fuel IGNI and TEST IGNI
6
6
24
EN
begins, where pellets are dosed quickly and fans
start, until the boiler reaches conditions for
P1A
P1D
P2A
P2D
P3A
P3D
P4A
P4D
P5A
P5D
P6A
P6D
7:30
P1t 70
9:30
12:30
P2t 75
14:30
8:30
P3t 80
10:00
15:30
P4t 72
17:30
16:30
P5t 65
22:45
17:30
P6t 85
21:30