Accessories; Inserting The Batteries - REVELL OUT SPEEDER Bedienungsanleitung

vehICLe:
Antenna
Wheels with
foam-rubber tires
reMOTe CONTrOLLer:
Signal indicator
Forward / backward
1. Unscrew the cover and pull-off in
the direction of the arrow.
Special rollover bars ensure that the car can flip-over and land
back on its wheels undamaged and then continue driving (Fig.1).
Insert the ends of each rollover bar into the holes provided on
the car (Fig. 2) until they snap in place (Fig. 3).
Attention: Allow the battery to cool-off for 10-15 minutes prior to recharging and after each drive, otherwise the car's battery may become damaged. Do not leave the car unattended during the
charging process.
Charging with the uSB-cable:
1. Switch-off the car! (Fig. 1)
2. Connect the USB-cable to the car. Do not apply force (Fig.2).
3. Connect the other end of the USB-cable to a PC that is switched-on (Fig. 3).
4. The charging process takes approx. 20 minutes if the battery is completely empty. The USB-
cable lights-up red after the battery is completely charged. For safety reasons never charge
the battery for longer than 20 minutes.
5. Disconnect the USB-cable from the PC and the car.
Fig. 1 Fig. 2
6
vehicle and remote control
Antenna

Inserting the batteries

2. Insert 4 x 1.5 V AA-batteries and
make sure to follow the polarity
information indicated on the inside of
the battery case.
Attaching the rollover bar
Fig. 1
Rollover bar
USB-cable connection

ACCeSSOrIeS:

Turbo-button
Right / left
3. Close the battery case cover.
Fig. 2
Charging the car
Charging with the charger:
1. Switch-off the car! (Fig. 1)
2. Connect the charging cable to the car. Do not apply force (Fig.2).
3. Switch-on the charger. The LED on the charger starts to flash green as soon as the charging
process starts. (Fig. 3)
4. The charging process takes approx. 20 minutes if the battery is completely empty. The green
flashing LED goes out after the battery is fully charged. For safety reasons never charge the
battery for longer than 20 minutes.
5. Disconnect the charging cable from the car and switch-off the charger.
Fig. 3
USB-cable
Fig. 3
The car can be driven for approx. 20 minutes
following a charging time of approx. 20 minutes.