Restore The Link Between The Transmitter And Receiver - Reely Lama 5 Bedienungsanleitung

12 Restore the link between the transmitter and receiver
The transmitter and receiver are already correctly preset at the factory. It is normally not neces-
sary to restore the link. Only after changing the receiver or transmitter or to correct an error (see
Section 15) might it be necessary to carry out this procedure.
To restore the link between the transmitter and receiver, proceed as follows:
• Disconnect the flight battery from the helicopter.
• Switch the transmitter off.
• Remove the cabin.
• For safety reasons, disconnect the servo and the motor cable from the receiver.
• After completing the link-up, be sure to plug all the plugs back in, doing so in the correct position with
the correct polarity.
• Plug the link-up cable(1) onto the connection for the roll servo.
• Connect the flight battery to the receiver.
• The red Bind/Status LED(2) will begin to blink.
• Press the BIND button(3) on the transmitter and hold it down.
• Switch the transmitter back on(4).
• The red Bind/Status LED(2) will stop blinking shortly. The procedure is then finished.
• Disconnect the flight battery from the receiver.
• Switch the transmitter off.
• Remove the link-up cable(1) from the receiver.
Plug the motor cable and servo cable back onto the receiver and put the cabin on.
•
• Switch the transmitter back on.
• Connect the flight battery to the receiver.
• Test the functioning and range of the remote control system.
Note: In normal operation, the Bind/Status LED(2) remains lit up red as long as the receiver is
receiving a proper signal from the transmitter.