Mounting - Conrad Profi Bedienungsanleitung

Remote Outdoor Sensor
The Remote Outdoor Sensor included with the basic shipment allows the
transmission of the temperature and humidity values at its mounting location.
This sensor can be addressed freely for display within the outdoor display section
in the upper right part of the LCD (see Display Overview). By default all Remote
Outdoor Sensors are set to Sensor 1. Individual addressing is however possible.

7. Mounting

Base Station
The Base Station can be placed on any smooth surface (e.g. table, bookshelf, etc.)
by means of a swivel-mounted control unit or wall mounted at any desired location
by means of a hanging hole at the back of the device.
Important Note!
It is recommended to check that the 433MHz signals as well as the DCF-77
time code signals are properly received before permanently
mounting the Professional Weather Station (drilling of holes, etc.).
Should the Weather Station not pick up signal from the desired
!
location a slight relocation will help in most any case. Once the
signals are received, the system can be mounted permanently.
Mounting is but a preparation for the setup. Just before the final
setup of the Base Station the magnets have to be placed into the sensors.
Recommendation!
In order to test all sensor functions at first setup the sensors can prior to
mounting be placed on a smooth surface (table, etc.) and put into operation
(see Item 8 Setting Up).
Remote Wind Sensor
South North
Magnet
Solar cell
37