Switch The Device On/Off; Connecting A Playback Device; Connecting A Playback Device Using A 3.5 Mm Jack Cable - Silvercrest SSTB 10 A1 Bedienungsanleitung Und Sicherheitshinweise

Switch the device on/off
On the device
♦ Press and hold down the
on the device. The message
the most recently used operating mode (
♦ Press the
The message
With the remote control
♦ Press the
♦ Press the

Connecting a playback device

You can connect a wide variety of playback devices to this device, for
example MP3 or CD players. Please refer to the operating instructions of the
respective device. Switch off all devices before connecting them.
NOTE
► When playing back music via the AUX connections, the
(
inactive. You can, however, turn the MUTE function on and off using the
button
device that you have connected.
► Before starting playback, set a moderate volume. When you reach the
maximum volume, you will hear a signal and the volume can no longer be
increased.
Connecting a playback device using a 3.5 mm jack cable
♦ Connect the line-out connector of the external device (e.g. headphone socket)
via a 3.5 mm jack cable to the AUX 1 socket
♦ To switch on the device, press the
Press the FUNCTION button
♦
the remote control repeatedly until
♦ Switch on the connected playback device and start playback.
SSTB 10 A1
button again for approx. 2 seconds to switch off the device.
appears briefly on the display
button to switch on the device.
button again to switch off the device.
+ ) and ( +
. Use the Play/Pause and skip functions on the external playback
button for approx. 2 seconds to switch
appears briefly on the display
or
) buttons on the unit and the remote control are
on the rear of the device.
button ( or
on the device or the AUX button
appears on the display
and then
) is shown.
.
+ ) ,
(
).
on
.
│ 11
GB
■