Troubleshooting; Environmental Regulations And Disposal Information; Removing The Battery - Powerfix Profi PLS 10 A2 Bedienungsanleitung Und Sicherheitshinweise

Powerfix PLS 10 A2

10. Troubleshooting

Battery LED emitter does not illuminate
 Check the position of the On/Off switch (9).
 The built-in battery may be discharged. Recharge it.
Battery does not charge
 The wall plug battery charger (B) is defective. Check if you can charge it with the 12/24 V
car charger cable (C).
 12/24 V car charger cable (C) defective. Verify if the green LED indicator on the 12/24 V
car charger cable (C) plug is on after inserting it into a powered cigarette lighter. If not,
replace the fuse of the 12/24 V car charger cable (C) as described in "Replacing the
fuse"

11. Environmental regulations and disposal information

Cardboard packaging can be taken to paper recycling centres or public collection points for
recycling. Any film or plastic contained in the packaging should be taken to your public
collection points for disposal.

11.1. Removing the battery

This battery LED emitter (A) contains a built-in battery pack. It must be removed before
disposing of the battery LED emitter (A).
To remove it, proceed as follows:
14 - English
Devices marked with this symbol are subject to the European Directive
2012/19/EU. All electrical and electronic devices must be disposed of
separately from household waste at official disposal centres.
Avoid damage to the environment and risks to your personal health by
disposing of the device properly. For further information about proper
disposal, contact your local government, disposal bodies or the shop
where you bought the device.
Dispose of all packaging in an environmentally-friendly manner.