Connecting The Hydraulic Lines - Kärcher MIC 34C Betriebsanleitung

8.7.4

Connecting the hydraulic lines

 Remove the protective caps from the hydraulic cou-
pling and connect the hydraulic hoses with the respec-
tive couplings.
 Connect the protective caps to each other to protect
from contamination.
8.7.5 Connecting the tail lights
 Connect the plug on the rear of the sweeper.
 Secure the cable if necessary to prevent it from being
pulled in by moving parts.
8.7.6 Operations
 Switch on the PTO to switch on the control
8.7.7 Prerequisites for operation
– Set the motor speed to "eco", the lower level of the
range.
50
8.8 Chassis mounted spreader
1 Chassis mounted spreader
2 Work light
3 Retainer for support (4x)
8.8.1 Securing the chassis mounted spreader
 Crank up the chassis mounted spreader with the sup-
ports to the required height until the rear retainer of the
carrier vehicle fits underneath.
 Open the safety bolts at the chassis mounted spreader
prior to placing it on the vehicle, for this purpose, turn
the lever on the inside in a counter-clockwise direction
(left and right).
1 Safety pin
2 Lever
 Position the vehicle under the chassis mounted spread-
er that is standing on the supports.
 Lower the chassis mounted spreader into the guides of
the rear structure.
 When attaching the chassis mounted spreader to the
vehicle for the first time, the left and right front guide
must be adjusted.
16
-
EN