Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Assembly
Attach wheels and unfold
Attach the wheels by pressing the unlock button in the
middle of the hub and insert the wheel into the desig-
nated socket on the base. Please make sure that the
wheels are properly locked before use, by pulling the
wheel towards you away from the wheelchair. (Pictures
1+2).
Unfold the wheelchair by pushing the seat until it locks
in place.
Mounting footrests
Mount both footrests as shown in (Pictures 3) and move
them to the inside until you perceive a clear audible
snap (Picture 4). Pull the lever upwards and move the
footrest to the outside, in order to release/ remove them
(Picture 5).
Adjusting length and inclination of footrests
Adjusting length (Picture 6)
Open and remove screw on the inside of the footrest
with the allen key and adjust the length to fit your needs.
Check where the threaded hole is and install the locking
screw.
Tighten screws!
Adjusting inclination (Picture 7)
Undo the screw on the side of the footrest (plate) with
an allen key and pull it out of the gearing. Then push the
plate back into the gearing after adjusting the inclination
Retighten screws!
Adjusting seat height
The height of the seat can be adjusted in four positions
ranging from 45 cm to 50 cm. Remove both wheels by
pushing the release button in order to adjust the height.
Open the nut on the wheel receiver and move it to the
desired drilling. Install the nut with the lock washer and
tighten it. (Pictures 8).
Make sure the nut is securely tightened!
Adjusting sitting height
(wheel receiver, front wheels)
The sitting height in the front can be adjusted in 3 po-
sitions as well as the desired inclination. Remove the
screw from the axle in order to adjust. The plugs in the
holes are easily replaced. Adjust the height and tighten
the screw. (Pictures 9).
Make sure the axle is securely tightened!
14
1
3
4
6
8
9
2
5
7 7
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
