Assembly; Mounting Wheels; Assembling Footrests; Adjusting Footrests - Drive Ecotec Gebrauchsanweisung

EN

Assembly

Attach wheels and unfold
Attach the wheels by pressing the unlock button in the
middle of the hub and insert the wheel into the designated
socket on the base. Please make sure that the wheels are
properly locked before use, by pulling the wheel towards
you away from the wheelchair.
Unfold the wheelchair by pushing the seat until it locks
in place.
Mounting footrests
Mount both footrests as shown in and move them to the
inside until you perceive a clear audible snap. Pull the
lever upwards and move the footrest to the outside, in
order to release/ remove them.
Adjusting length of footrest
Adjusting length
Open and remove screw on the inside of the footrest with
the allen key and adjust the length to fit your needs. Check
where the threaded hole is and install the locking screw.
Tighten screws!
10
Adjusting seat height
desired drilling. Install the nut with the lock washer and
tighten it.
Make sure the nut is securely tightened!
Adjusting sitting height (front wheels)
Make sure the axle is securely tightened!
Adjusting and removing armrest
When delivered, the armrest are already mounted to the
wheelchair.
The armrests are replaceable.
To fold back the armrest, you must push the lever on
the front of the armrest and pull back the armrest at the
same time.
The height of the seat can
be adjusted in two posi-
tions.
Remove both wheels by
pushing the release but-
ton in order to adjust the
height.
Open the nut on the wheel
receiver and move it to the
The sitting height in the
front can be adjusted in
3 positions as well as the
desired inclination.
Remove the screw from
the axle in order to adjust.
The plugs in the holes are
easily replaced.
Adjust the height and tigh-
ten the screw.