System Setup - Dometic M9LQ Bedienungsanleitung

M9LQ
8.10

System setup

In the system setup sub-menu, the screen display settings can be made.
Parameter
Rec-V out
Autoscan
Scan delay
Jump key
Power on
Beep
System
Dimmer
EN
Description
Output signal on the recording output
Left, Right, Front, Back: The respective camera image
Quad: All four cameras (fig. e, page 9)
Auto search (chapter "Automatic search" on page 56)
Display time while during auto search
(chapter "Automatic search" on page 56)
The display can be opened by pressing the "S" button on
the monitor. The following can be selected:
Left, Right, Front, Back: The respective camera image
More camera displays: (fig. e, page 9)
Once the ignition is on, the monitor switches into the set
mode. The following can be selected:
Left, Right, Front, Back: The respective camera image
More camera displays: (fig. e, page 9)
Standby: The monitor switches to standby.
Setting for confirmation signal.
On: Confirmation signal for any action using the touch
monitor, the control buttons or the remote control
Off: Confirmation signals off
Video standard (PAL/NTCS)
The brightness of the monitor.
00 – 04: Brightness levels (00: dark, 04: bright)
Auto: The brightness sensor controls the brightness of the
monitor.
Using the LCD monitor
55