Using The Lcd Monitor; Switching On The Monitor; Setting The Display Mode; Switching Off The Monitor - Dometic M9LQ Bedienungsanleitung

Using the LCD monitor

8 Using the LCD monitor
8.1

Switching on the monitor

➤ If the monitor is switched off, press the "P" button to switch the monitor on.
✓ The button lights up green.
✓ Depending on how the monitor is connected, the image appears:
– directly connected to the battery: the previous screen configuration
selected
– connected to the ignition: the screen configuration set in the "System
setup" sub-menu, "Power on" parameter.
8.2

Setting the display mode

To set the display mode, proceed as follows:
➤ If you would like to switch to a display mode, press the " " button.
✓ The monitor runs through the different display modes.
I
NOTE
If you want the cameras to run automatically: see chapter "Setting the auto-
matic search" on page 56.
8.3

Switching off the monitor

➤ Press the "P" button to switch off the monitor.
✓ The button lights up red.
✓ The picture disappears.
8.4

Set the language

The language in the menu is English by default. You can set the menu language
as follows:
➤ Press the "M" button to open the main menu.
➤ Press the "S" button until "OSD setup" is highlighted in green.
➤ Press the "–" button or the "+" button to open the sub-menu.
➤ Press the "S" button until "Language" is highlighted in green.
➤ Press the "–" button or the "+" until the menu in the required language
appears.
50
M9LQ
EN