5....-05-WKS 2775
Overview of Components
1
Lid unlocking device
2
Lid
3
Handle
4
Water container
Before using the machine for the first time water should be boiled in it twice without
any additives. Do not use this water.
1. Press the button (1) on the lid (2) in order to open it. Fill it with water. Do not
overfill!
2. Place the kettle flush on the base (7). Only connect the machine to a properly
installed 230 V, 50 Hz safety socket. Switch on the appliance with the relevant
switch (6). The control lamp (5) will light up. After boiling the machine switches
off automatically. Disconnect the machine from the mains electricity supply.
When pouring, do not press the lid too much. Danger of burns!
•
Always remove the plug from the mains supply before cleaning the machine!
•
The exterior of the machine should be cleaned, if necessary, with a slightly
damp cloth without additives.
•
The machine must never be immersed in water!
The decalcification intervals depend on the hardness of the water and the frequen-
cy of use. Decalcification should be carried out every 3 to 4 months.
If the machine switches off before the water boils, it probably needs to be decalci-
fied.
Please do not use vinegar but a commercially available decalcification agent on the
basis of citric acid. Only use the quantities stated in the instructions.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
28.01.2003 16:38 Uhr
First Use of the Machine
Cleaning
Decalcification
Seite 23
5
Control lamp
6
On/off switch
7
Base
GB
23