Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning The Cooking Compartment; Removing And Fitting The Appliance Door - Junker JB33UK50 Gebrauchsanleitung

Einbaubackofen
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Cleaning the cooking compartment

Caution!
Risk of damaging the surface. Do not clean the appliance while
still warm, even if using oven cleaners specially intended for
this purpose.
Notes
Due to its technical properties, the enamel may exhibit colour
variations. However, this has no effect on the function.
The edges of thin trays may be rough. Anti-corrosion
protection is still guaranteed, however.
Appliance part
Cleaning agent/aid
Enamel surfaces
Apply washing-up liquid or vinegar solu-
(smooth surface)
tion with a soft, damp cloth or chamois;
dry with a soft cloth. Soften baked-on
food residues with a damp cloth and
detergent. Leave the cooking compart-
ment open to dry after cleaning.
We recommend using oven cleaner if the
oven is very dirty. Observe the manufac-
turer's instructions when cleaning with an
oven cleaner.
Self-cleaning sur-
Please see the notes in section: Self-
faces
cleaning surfaces
(rough surface)
Door seal
Hot soapy water
Hook-in racks
Hot soapy water:
Soak and clean with a dish cloth or brush.
Accessories
Soak in hot soapy water. Clean with a
brush and sponge or wash in the dish-
washer.
Keeping the appliance clean
Clean the cooking compartment every time it is used, since dirt
will be burnt on next time the oven heats up and will thus
become hard to remove. Always remove flecks of limescale,
grease, starch and albumin (e.g. egg white) immediately.
Where possible, use the
~
operating mode causes less soiling.
Self-cleaning surfaces
The back panels and side panels of the cooking compartment
are coated with self-cleaning enamel. This coating absorbs and
disintegrates splashes from baking and roasting while the oven
is in operation.
Large splashes only disappear after the oven has been used
several times.
Discolouration on the self-cleaning surfaces does not affect the
self-cleaning function.
Caution!
Damage to surfaces on self-cleaning areas due to applying
oven cleaner.Never clean the self-cleaning surfaces with oven
cleaner.
If oven cleaner accidentally gets onto self-cleaning surfaces,
remove it immediately with a sponge and plenty of water.
Caution!
Damage to surfaces on self-cleaning areas due to the use of
abrasive and acidic cleaning agents and aids.
Do not use cleaning agents containing abrasive substances or
acids.
Do not use abrasive cleaning aids such as steel wool or
scourers.
2D-Hot air operating mode. This

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
:
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
:
Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the after­sales service.
Removing the appliance door
Open the appliance door fully.
1.
Open the locking levers on the left and right-hand side fully.
2.
The hinges are secured and cannot snap closed.
Close the appliance door until resistance becomes
3.
noticeable (figure A).
With both hands, grip the door on the left and right-hand side,
4.
close the door a little more and pull it out (figure B).
Fitting the appliance door
Insert the hinges in the left and right-hand holders (figure C).
1.
The notch on both hinges must engage.
Open the appliance door fully.
2.
Close the locking levers on the left and right-hand side fully
3.
(figure D).
The appliance door is secured and can no longer be
removed.
Close the appliance door.
4.
67

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis