Programming Additional Transmitters; Deleting Transmitters - Becker VC520 Betriebsanleitung

Press the programming button of the transmitter for 3 seconds whilst in pro-
gramming mode.
► The receiver confirms programming, i.e. the shading solution moves a
few centimetres before reversing the same distance.
The programming process is now complete.

Programming additional transmitters

In addition to the master transmitter, up to 15 further trans-
mitters (of which a maximum of three can be sensors) can be
programmed in the radio receiver.
Press the programming button of the master transmitter for 3 seconds.
▻ The receiver confirms.
Now press the programming button of a new transmitter which has not yet
been programmed in the radio receiver for 3 seconds. Doing so activates the
programming mode of the radio receiver for a new transmitter for 3 minutes.
▻ The receiver confirms.
Now press the programming button of the new transmitter you wish to pro-
gram again for 3 seconds.
▻ The receiver confirms.
► The new transmitter has now been programmed.

Deleting transmitters

Deleting individual transmitters
The programmed master transmitter cannot be deleted. It
can only be overwritten.
Press the programming button on the master transmitter for 3 seconds.
▻ The receiver confirms.
Now press the programming button of the transmitter to be deleted for 3
seconds.
▻ The receiver confirms.
27 - en