Default Setting; Programming - Becker Centronic UnitControl UC52 Montage- Und Betriebsanleitung

Assembly and Operating Instructions
Moving to intermediate position
You should only move the shutter or blind to the intermediate position or pro-
gramme it from the upper end limit.
Press the DOWN button twice in rapid succession. The curtain will move to the
stored intermediate position.
Moving to ventilation position
You should only move the shutter or blind to the ventilation position or pro-
gramme it from the lower end limit.
Press the UP button twice in rapid succession. The curtain will move to the
stored ventilation position.
Encoding switch setting:
1. Lower position
2. Lower position
3. Lower position
Programming the intermediate position
Prerequisite: the roller shutter / blind is at the upper end limit.
1. Press and hold the intermediate position programming button t.
2. Press the DOWN button at the same time until you have reached the re-
quired intermediate position. Adjustments can be made using the UP button
or DOWN buttons.
3. Release the intermediate position programming button t. The intermediate
position has now been saved.
The alarm signal control light will flash briefly three times.
Deleting the intermediate positions
1. Press the intermediate position programming button t for longer than 5 sec-
onds. The intermediate position has now been deleted.
The alarm signal control light will flash briefly three times.
24

Default setting

Alarm signal function on.
Drive controller
Roller shutter/awning mode

Programming