Weighing-In With Deltadisplay - Mettler Toledo AE160 Bedienungsanleitung

OPERATION: How to weigh-in using DeltaDisplay
The AE balances are equipped with DeltaDisplay; this is a display mode which can be switched on and off, and which is especially suitable for weighing-in. When
weighing-in, the increasing weight is displayed almost without delay by rapidly changing numbers. In addition, when there are fast weight changes, the last two digits
are blanked out to enable you to follow the increasing weight. The stability detector is switched on together with the DeltaDisplay. This permits only stable weight
results to be released to the data interface.
Weighing-in
– Place container on the weighing pan.
– Press control bar (1) to tare:
zero display appears.
– Weigh-in up to desired target weight.
If different components must be weighed in, one after
the other, tare can be pressed after each component
is weighed in, and the next component can be
weighed in from zero until the container and all
components equal the capacity of the weighing
range.
If the weighing range is exceeded, the upper portions
of all digits appear: "- - - - - - - -".
DeltaDisplay
As the component is being filled in quickly, the
DeltaDisplay automatically switches in: the last two
decimal places (13) are blanked out and the display
change is speeded up. This allows the weight
increase to be followed better.
DeltaDisplay is switched off when the stability detector
(ASd) is configured "OFF".
32. 3 456
When filling in is slowed down to approach the target
weight, the last two digits automatically reappear.
The display change continues to be speeded up.
Only when very small weight changes are made,
does the balance switch back to the normal display
rate.
In this way, a stable weighing result is displayed
with full accuracy.
13
9