Package, Transport And Storage; Delivery; Transport; Storage - Homa TP22 Originalbetriebsanleitung

Due to the direct connection of the float switch in the pump, the pump will automatically turn on if the
switch is manually triggered! Therefore, make sure that the pump is not connected if you are performing
work on it.
3.3.4. Sealing / Seal housing
The seal is created by a lip seal and a silicon carbide mechanical seal.
3.3.5. Pump casing
The pump casing is equipped with a DN50 / R2" IG pressure connection.
3.3.6. Impeller
The impeller is fixed on the engine shaft which powers it. The impeller is an open single-blade wheel in the M
version, which is suitable for muddy materials containing solids or fibrous admixtures.
The vortex impeller is used for the V version. This is suitable for gas- or air-containing materials with rough or
fibrous, stringy components liable to twist.
The free passage depends on the pump type:
TP22... 22mm
TP26... 26mm
TP35... 35mm
4. Package, Transport, Storage

4.1. Delivery

On arrival, the delivered items must be inspected for damage and a check made that all parts are present. If any
parts are damaged or missing, the transport company or the manufacturer must be informed on the day of
delivery. Any claim made at a later date will be deemed invalid. Damage to parts must be noted on the delivery or
freight documentation.

4.2. Transport

Only the appropriate and approved fastening devices, transportation means and lifting equipment may be used.
These must have sufficient load bearing capacity to ensure that the product can be transported safety. If chains
are used they must be secured against slipping.
The personnel must be qualified for the tasks and must follow all applicable national safety regulations during the
work.
The product is delivered by the manufacturer/shipping agency in suitable packaging. This normally precludes the
possibility of damage occurring during transport and storage. The packaging should be stored in a safe place if
the location used is changed frequently.

4.3. Storage

Newly supplied products are prepared that they can be stored for 1 year. The product should be cleaned
thoroughly before interim storage.
The following should be taken into consideration for storage:

Place the product on a firm surface and secure it against falling over. Submersible mixers and
auxiliary lifting devices should be stored horizontally, submersible sewage pumps and submersible
motor pumps should be stored horizontally or vertically. It should be ensured that they cannot bend
if stored horizontally.
Danger from falling over!
Never put down the product unsecured. If the product falls over, injury can occur!

The product has to be stored at a place free from vibrations and agitation to avoid damage from the
ball bearings. We recommend a dry, frost-protected room with a temperature of between 5 °C and
25 °C for storage.

The product may not be stored in rooms where welding work is conducted as the resulting gases
and radiation can damage the elastomer parts and coatings.

It is responsible to take care that the corrosion coating will not be spoiled

Any suction or pressure connections on products should be closed tightly before storage to prevent
impurities.

The power supply cables should be protected against kinking, damage and moisture.
33