Operation; Stand-Alone Operation; Master/Slave Operation; Control Board - EuroLite LED TMH-X3 Bedienungsanleitung

OPERATION

After you connected the effect to the mains, the EUROLITE LED TMH-X3 starts running. During the Reset,
the motors are trimmed and the device is ready for use afterwards.

Stand-alone operation

In the Stand-alone mode, the LED TMH-X3 can be used without controller.
Disconnect the LED TMH-X3 from the controller and call the internal program. Please refer to the instructions
under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired master mode for the master device. Set the slave mode for all slave devices.
Please refer to the instructions under Control Board.

Control Board

The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or make a reset.
The main menu is accessed by pressing the Menu-button. Browse through the menu by pressing Up or
Down. Press the Enter-button in order to select the desired menu. You can change the selection by pressing
Up or Down. Confirm every selection by pressing the Enter-button. You can leave every mode by pressing
the Menu-button. The functions provided are described in the following sections.
Default settings shaded.
Main menu
Address
CH Value
Slave
Function
Auto
Music
Temp Inf
Info
Soft Inf
Status
Person
Temp C/F
Default
Reset
Reset
Adjust Calit CH
Sub menu
001 -XXX
PAN ...
Slave
Master-A/Alone-A
Master-M/Alone-M
Head Temp
V X.X.X ...
PAN Rev
TILT Rev
P-Degree
Mic Sens
C/F switch
YES/NO
Password
PAN
TILT
ZOOM
26/32
Display
DMX address setting
DMX indicator
Slave setting
Auto program
Music control
XXX°C/°F Inside temperature
Software version
YES/NO
Reverse movement
YES/NO
360/540 Select PAN-angle 360° or 540°
0~99%
Mic sensitivity
Select temperature
designation °C or °F
Reload Default
Reset all
Password=XXX
PAN=XXX
Calibration to standard
position password „050"
TILT=XXX
ZOOM=XXX
Function
00103072, Version 1.0