Checking The Transmitter's Operating Time; Erasing The Timer Erase - Multiplex PROFI car 403 Bedienungsanleitung

The transmitter can only produce this signal if your car has completed at least six
laps. The transmitter computes the average time for the last six laps, then calculates
whether a further full lap can be completed in the time remaining to the end of the
race. If not, the 3-beep signal is given. When you next press the handle button the
transmitter stops the timing process.
This is the procedure:
§
Search for the menu point DURA using the
§
Select T (time) or LAP (laps) with the handle button
§
Alter the value using the digi-adjustor
Press any menu button (except
6.5.

Checking the transmitter's operating time

This menu point can only be used to check the operating time.
To erase the data you must proceed to the ERASE menu point.
§
Select the menu point OPER using the
The time is displayed in hours and minutes.
Press any menu button (except
6.6.

Erasing the timer ERASE

This menu point can be used to erase the following times (or settings):
Item
L+T L+T
NOM NOM
DURA DURA
OPTIME OPTIME
This is the procedure:
§
Search for the menu point ERASE using the
§
M Use the digi-adjustor to select the item you wish to erase
§
Hold the handle button
Press any menu button (except
º
) to return to the operating display.
º
) to return to the operating display.
this value is erased (reset to 0):
The lap counter and all time memories
Set nominal lap time
Time and lap count for the race duration
Operating time
G
pressed in for longer than 3 sec to erase the data
º
) to return to the operating display.
º
button
º
button
º
button
36
G
OPTIME
6: 1 7