Multiplex PROFI car 403 Bedienungsanleitung Seite 162

The diagram on the right
shows an example of the
settings you can change in
the „S-TRAV" menu. The
stated angles (0° / 45°) show
the servo's maximum phy-
sical travel. The adjustment
points „L L " and „Œ Œ " indicate
the maximum travel of the
steering servo which the
user has set. To adjust either
of these points you have to
turn the steering wheel in
the corresponding direction.
When the servo is at the „• • " point you can adjust the servo setting for „straight".
In the „S-NORM" menu point
you can also set the direction of rotation for the servo, and choose between the
MULTIPLEX and UNIVERSAL signal formats. MULTIPLEX norm means that the signal
length (pulse width) for the centre setting is 1.6 ms, and the signal range is
+/- 0.55 ms. The UNIVERSAL norm means that the servos operate on 1.5 ms +/-0.5 ms.
This is the procedure:
S S - - NORM NORM
S S - - TRAV TRAV
L
Search for menu
point
Select servo 1
Select norm and
direction of
rotation
Search for menu
Point
Select servo 1
Select right, centre,
left by rotating
steering wheel,
then set using digi-
adjustor
18
S-NORM
1: MR
UN
UNI normal
UR
UNI reverse
MN
MPX normal
MR
MPX reverse
S-TRAV
1: •- 3
%
right
Œ Œ
centre
• •
left
L L
0 – 100 %
+/- 25 %
0 – 100 %