Notes About The Remote Control; Battery Installation; Battery Replacement; Unpacking - Yamaha CDX-397MK2 Bedienungsanleitung

Carefully remove this unit and accessories from the box. You should find the unit itself and the following accessories.
Remote control
DIMMER
SYNCHRO

NOTES ABOUT THE REMOTE CONTROL

Battery installation

1. Turn the remote control over and remove the battery
compartment cover by sliding it in the direction of the
arrow.
2. Insert the batteries (AAA, R03, UM-4) according to the
polarity markings on the inside of the battery
compartment.
3. Close the battery compartment cover.
%
Press

Battery replacement

If you notice that the remote control must be used closer to
the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
Use only AAA, R03, UM-4 batteries for replacement.
Be sure the polarities are correct. (See the illustration inside the
battery compartment.)
Remove the batteries if the remote control is not used for an
extended period of time.
If batteries leak, dispose of them immediately. Avoid touching
the leaked material or letting it come in contact with clothing,
etc. Clean the battery compartment thoroughly before installing
new batteries.

UNPACKING

OPEN/CLOSE
1 2 3 4
5 6 7 8
9 0 INDEX
RANDOM
REPEAT A–B PROGRAM CLEAR
TAPE PEAK SPACE
SEARCH
TIME/INFO
FOLDER
FILE FILE
ENTER
OUTPUT
LEVEL
FOLDER
Audio pin cable
Batteries (AAA, R03, UM-4) x 2

Remote control operation range

Remote control
sensor
Within approximately
6 m
Notes
There should be no large obstacles between the remote control
and the main unit.
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type fluorescent lamp etc.), the
remote control might not work properly. In this case, reposition
the main unit to avoid direct lighting.
3
En