Manual Tape-Programming (For Audio Cd) - Yamaha CDX-397MK2 Bedienungsanleitung

This is for recording desired tracks in any order onto a tape.
3, 5
4
1
Follow steps 1 – 3 on page 16.
2
Press PROGRAM.
PROGRAM
3
Use numeric buttons to select desired tracks (to be
recorded on the side A) in any order.
* Programmed track numbers light up on the display.
4
When track selection for side A is finished, press
TAPE.
TAPE
A pause is inserted.
18
En

Manual tape-programming (for Audio CD)

1 2 3 4
5 6 7 8
9 0 INDEX
DIMMER RANDOM
REPEAT A–B PROGRAM CLEAR
2
SYNCHRO TAPE PEAK SPACE
SEARCH
Blinks.
1 2 3 4
5 6 7 8
9 0
7, 8
5
Use numeric buttons to select the track numbers (to
be recorded on the side B) in any order.
PROG.
6
Press PROGRAM.
7
Start recording on the tape deck, and then press
8
This unit automatically pauses at the end of the side
A. Turn the tape over to the side B, resume
recording on the tape deck, and then press
playback.
Notes
If, in step 3 or 5, "Err" appears on the display, the track number
just selected cannot be programmed because there is not
enough time remaining on the tape.
In step 3 or 5, each time a selection is made, the track number
and the remaining time of the tape is displayed, and then the
display changes to indicate the next program number.
PROG.
You can check, cancel or correct program data. (For details,
refer to page 15.)
* When checking program data, note that "Pu" appears
between track numbers for side A and side B.
Up to 40 tracks can be programmed. If, however, a pause is
inserted, it is counted as one track.
CD synchronized recording function can be used if your tape
deck is compatible with it. If so, in step 7 and 8, press
SYNCHRO and then press
unit. Recording automatically starts. (For details, refer to page
21.)
DIMMER RANDOM
REPEAT A–B PROGRAM CLEAR
SYNCHRO TAPE PEAK SPACE
SEARCH
TIME/INFO
FOLDER
1 2
5 6
9 0
on the remote control of this unit.
on the remote control of this unit to start
on the remote control of this
6
8
3 4
7 8
or