Insertion / Removal Of A Battery Pack Into The Appliance; Checking Battery Status; Changing Tools; Torque Pre-Selection - Parkside PABS 18-Li B2 Originalbetriebsanleitung

Note! A new battery pack, or one that has not
been in use for an extended period, must be charged
up before the first / renewed usage.
The battery pack attains its full capacity after ca.
3–5 charging cycles.
CAUTION! Always ensure the plug is removed
from the mains socket before inserting a battery pack
into, or removing one from, the charging station.
N ever charge the battery pack if the ambient
temperature is less than 10 °C or greater than
40 °C.
1. Insert the battery pack
charger (see Fig. C).
15
2. Insert the mains plug into the mains socket. The
flashing green charge indicator LED
that charging is in progress.
3. The charging process is completed when the
green charge indicator LED
accumulator pack
4. If the red charge indicator LED
quick battery charger
the accumulator pack
5. If the red charge indicator LED
hing, this means that the accumulator pack
has become too hot; no charging process.
N ever charge the battery pack for a second time
immediately after a fast charging process has
been completed. This can give rise to the battery
pack becoming overcharged and to a reduced
service life of the battery and charging station.
S witch the charger off for at least 15 minutes
between two successive charging procedures.
Remove the power plug from the wall socket.
Insertion / removal of a battery
Q
pack into the appliance
Ensure that the appliance is switched off before in-
serting the battery. The insertion of a battery into an
electrical appliance that is switched on can lead to
accidents.
into the quick-
6
shows
17
light up and the
17
is ready for operation.
6
lights up, the
16
is in standby mode;
15
is not connected.
6
starts flas-
16
Inserting the rechargeable battery pack:
Move the rotation switch
position (lock) and push the rechargeable bat-
tery pack
6
Removing the rechargeable battery pack:
P ress the release button
rechargeable battery pack

Checking battery status

Q
T o check the battery status, press the battery
LED button
11
status or residual capacity will be indicated in
the battery LED
GREEN / RED / ORANGE = maximum charge /
capacity
RED / ORANGE = medium charge / capacity
RED = weak charge – recharge battery

Changing tools

Q
Your cordless electric drill / screwdriver has a fully
automatic spindle lock
6
enclosed keyless chuck incorporating the latest
technology from
Once the motor has come to a halt, the drive shaft
is automatically locked, so that the chuck
be opened simply by turning it
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch

Torque pre-selection

Q
You can adjust the torque by using
selection. The torque levels regulate a range of up
to ca. 35 Nm.
S elect a low setting for small screws, soft work
material.
Before first use
into the middle
2
into the handle until it engages.
and remove the
7
(refer to main diagram). The
as follows:
10
and is fitted with an
"Made in Germany".
.
, you can immedi-
).
3
torque pre-
14
can
13
GB 23