Attaching/Disconnecting The Battery Pack To/From The Appliance; Checking The Battery Charge Level; Fitting The Additional Handle; Changing Tools - Parkside PSBSA 20-Li B2 Originalbetriebsanleitung

♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes
between successive charging sessions . Also
disconnect the power plug from the mains
power socket .
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch
middle position (lock) . Allow the battery pack
to click into the handle .
Removing the battery pack:
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram) .
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Fitting the additional handle

♦ Screw the additional handle
right of the appliance depending on how you
work .

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . Once you have attached the desired tool
and tightened it by turning the chuck
continue working . The spindle lock is automatically
released when the motor starts (ON/OFF switch
pressed) .
PSBSA 20-Li B2
back into the appliance .
into the
and remove the
to
as follows:
onto the left or
, you can
Torque preselection/selecting the
operating mode
You can adjust the torque on the torque preselector
and select between the drill setting and the
hammer drill setting
♦ Select a low level for small screws or soft
materials .
♦ Select a high level for large screws, hard
materials or removing screws .
♦ Select the drill setting for drilling work by adjusting
the torque selection ring to the position .
♦ Select the hammer drill setting for hammer
drilling work by adjusting the torque selection
ring to the position

2-speed gearbox

CAUTION!
► Operate the speed selection switch
when the appliance is at a standstill . Other-
wise the appliance can be damaged .
In first gear (speed selector switch
position: 1)
you can reach a speed of approx . 440 rpm and a
high torque . This setting is suitable for all screwing
work but also for the use of accessories .
In second gear (speed selector switch
position: 2)
you can reach a speed of approx . 1650 rpm for
carrying out drilling work .

Use

Switching on and off

Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in .
The LED work light
OFF switch is depressed lightly or fully . This
allows for illumination of the work area in low
lighting .
.
.
only
in
lights up when the ON/
GB │ IE │ NI │ CY │
in
7 ■