Citizen iDP460P Benutzerhandbuch Seite 53

ESC d
[Name]
[Code]
[Function]
[Caution]
[See Also]
ESC e (n) ;
[Name]
[Code]
[Domain]
[Function]
Request Printer Status
<1B>H<64>H
In the P-250 mode and P-900R mode, this command sends the following 1-byte
status messages shown below. This command is valid only for the serial
interface.
Bit Code
0 L
1 X
2 X
3 X
4 X
5 1
6 F Mechanical error
7 P
This command is ignored for the parallel interface and in the P-200 mode. If
the paper runs out or there is a mechanical error, the data may not be
received.
ESC a
Set Right Margin
<1B>H<65H>(n)<3B>H
0 ≤ (n) ≤42 (<30>H ≤ n ≤<39>H)
In the P-250 mode and P-900R mode, this command controls whether the
characters should be printed or at which position of the line they should be
printed, when the buffer is full. When the parameter is set between 1 and 41,
the printer will print automatically when the n-th printable character is
received. If the parameter is set beyond these limits, printing will be
performed when the LF command is received.
Function
Paper end
Not defined
Not defined
Not defined
Not defined
Unused
Without error
Parity
53
iDP-460 User's Manual
P-250, P-900R
Value
0
With paper Without paper
- -
Fixed at 0
P-250, P-900R
1
Fixed at 1
With error
- -
CITIZEN