Inhaltsverzeichnis
Werbung
10.2
Command Sets
A command set is set by a specific command.
depending on each setting.
(1) P-250 command set
There are two kinds of modes; P-200 mode and P-250 mode. The P-900R mode are available
with a P-900R mode and P-250 mode command.
operate differently between the P-200 mode and P-250 mode.
In the P-200 mode, if the 40th character in the line is received, the contents of the buffer will
be printed automatically. In the P-250 mode, the default delimits at the 42nd character and
printing is performed only after the LF command is received.
(2) P-900R command mode
Basically, this mode is the same as the P-250 mode. It can be set by a command. With the
serial interface, if a paper end error is detected in this mode, "#" will be output as the TD
signal every second until the paper end error is reset.
The available commands and functions differ
The SI, SO, RS, US, and DC2 command
44
iDP-460 User's Manual
CITIZEN
Werbung
Inhaltsverzeichnis
