For Your Safety; Intended Use; Description - Dräger X-zone 5000 Gebrauchsanweisung

For your safety

Strictly follow the Instructions for Use
Any use of the device requires full understanding and
strict observation of these Instructions for Use. The
device is only to be used for the purposes specified
here.
Maintenance
The device must be inspected and serviced regularly by
trained service personnel. Repair of the device may only
be carried out by trained service personnel.
We recommend that a service contract be obtained with
Dräger and that all repairs also be carried out by Dräger.
Only genuine Dräger parts should be used for
maintenance.
Strictly follow the instructions in the chapter
"Maintenance intervals" on page 43.
Accessories
Do not use accessory parts other than those specified in
the order list on page 49.
Safe coupling with electrical devices
Electrical connections to devices which are not listed in
these Instructions for Use should only be made
following consultation with the respective manufacturers
or an expert.
Use in areas subject to explosion hazards
Devices or components for use in explosion-hazard
areas which have been tested and approved according
to national, European or international Explosion
Protection Regulations may only be used under
the conditions specified in the approval and with
consideration of the relevant legal regulations.
The equipment or components may not be modified
in any manner. The use of faulty or incomplete parts
is forbidden. The appropriate regulations must be
observed at all times when carrying out repairs on
these devices or components.
Safety symbols used in these Instructions for Use
These Instructions for Use contain a number of
warnings for risks and hazards which might occur when
using the instrument. These warnings contain signal
words which will alert you to the degree of hazard you
may encounter. These signal words and corresponding
hazards are as follows:
Indicates an immediate hazardous situation which,
if not avoided, could result in death or serious injury.
Indicates a potential hazardous situation which, if not
avoided, could result in death or serious injury.
DANGER
WARNING
Indicates a potential hazardous situation which, if not
avoided, could result in injury or damage to property.
It may also be used to alert against unsafe practices.
NOTICE
Additional information on how to use the device.

Intended use

The Dräger X-zone 5000 is an explosion-proof, portable
alarm amplifier for the quasi-stationary monitoring of
hazard areas. The Dräger X-zone 5000 can be used
together with the Dräger X-am 5000 gas detector
(certificates DEMKO 07 ATEX 143500X and IECEX
ULD 07.0004x). The device is only to be used in areas
known to have a low risk of mechanical impact. Several
Dräger X-zone 5000 devices can operate in a self-
crosslinking network.
NOTICE
The Dräger X-zone 5000 is intended for detection
in ambient air. Any increased exposure to certain
hydrocarbons can result in restrictions in the detection
quality of the sensors.

Description

The Dräger X-zone 5000 alarm amplifier is intended
for use under industrial conditions within a specified
temperature range for an uninterrupted operating period
of up to 5 days.
Via a wireless connection and/or communication cable,
several Dräger X-zone 5000 devices can be grouped
to form an alarm chain. In the event of an alarm, all
connected Dräger X-zone 5000 devices will issue
the alarm.
The alarm is generated using the gas detection
instrument Dräger X-am 5000. The Dräger X-am 5000
is connected via an infrared interface to the Dräger X-
zone 5000. In addition to alarm generation, the Dräger
X-am 5000 is used as the user interface for the Dräger
X-zone 5000. When the Dräger X-am 5000 generates a
gas alarm, this is transmitted to the Dräger X-zone 5000
and amplified acoustically and optically.
CAUTION
27