Multi-Source Recording / Playback; Last Function Memory; Initialization Of The Microprocessor - Denon AVR-3806 Bedienungsanleitung

Advanced Operation

Multi-source recording / playback

2 Playing one source while recording another
(REC OUT mode)
1
ZONE2/3/REC SELECT
Press the
"ZONE2 SOURCE" appears on the display.
2
With "ZONE2 SOURCE" displayed, turn the
FUNCTION
knob until "RECOUT SOURCE"
appears on the display.
• The REC indicator lights.
D V D
R E C O U T S O U R C E
3
With "RECOUT SOURCE" displayed, turn the
FUNCTION
knob to select the source you wish to
record.
4 Set the recording mode.
For operating instructions, refer to the manual of the
component on which you want to record.
• To cancel, turn the FUNCTION knob and select "SOURCE".
• Recording sources other than digital inputs selected in the REC
OUT mode are also output from the ZONE2 preout terminals.
• Digital signals are not output from the analog REC OUT
terminals.
• When the REC OUT mode is selected, the ZONE2 button on the
remote control unit cannot be operated.

Last function memory

• This unit is equipped with a last function memory which stores
the input and output setting conditions as they were
immediately before the power is switched off.
This function eliminates the need to perform complicated
button until
resetting when the power is switched on.
• The unit is also equipped with a back-up memory. This function
provides approximately one week of memory storage from
when the main unit's power switch is off and with the power
supply cord disconnected.
In very rare instances, the AVR-3806 internal microprocessor
might lock up, or otherwise cause mis-operation. This might be
caused due to an AC line surge or line spike noise, or by static
electric discharge on or nearby the unit, or to connected
components. If the condition cannot be corrected by powering
off the unit, including disconnection of the power supply cord for
a period of ten minutes and subsequent re-connection, then the
unit may have to be re-initialized. Doing so will restore the
microprocessor to its original out-of-the-box state, with all
custom memories and settings erased, and the original factory
default settings restored. Only use this procedure if you are sure
that the microprocessor requires re-initialization.
1
2
3
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the settings are reset
58
ENGLISH
Advanced Operation

Initialization of the microprocessor

Switch off the unit using the main unit's
switch.
PURE DIRECT
Hold the following
NIGHT
button, and turn the main unit's
switch on.
Check that the entire display is flashing with an
interval of about 1 second, and release your
fingers from the 2 buttons.
• The microprocessor will be initialized.
to the default values (the values set upon shipment from the
factory).
ENGLISH
POWER
button and
POWER