2.
Press
3.
Connect the black lead to the COM terminal and the red
lead to "+";
4.
Place the contact tips on the terminals of the component;
The voltage across the terminals of the component is displayed
on screen.
3.1.5
Capacitance measurement
Attention: all capacitance measurements must be made in a
power-off condition. Observe the connection polarity (+ to the
red terminal, - to the black terminal)
To measure the capacitance, proceed as follows:
1.
Make sure that the capacitor to be measured is
discharged;
2.
Set the switch to
3.
Connect the black lead to the COM terminal and the red
lead to "+";
4.
Place the contact tips on the terminals of the component;
The measured capacitance is displayed on screen.
twice. The
;
symbol is displayed ;
Forward direction
English
44 - 139