English
The measured resistance is displayed on screen.
3.1.3
Continuity test with buzzer
Attention: all continuity measurements must be made in the
absence of any voltage.
To test electrical continuity, proceed as follows:
1.
Set the switch to
2.
Press
3.
Connect the black lead to the COM terminal and the red
lead to "+";
4.
Place the contact tips on the terminals of the component
or circuit to be tested;
The buzzer indicates continuity; the measured resistance is
displayed on screen.
3.1.4
Diode test
Attention: all diode test measurements must be made in a
power-off condition.
To test a diode, proceed as follows:
1.
Set the switch to
43 - 139
;
. The
symbol is displayed ;
;