Commissioning; System Settings - VOLTCRAFT Ir 1200-50D USB Bedienungsanleitung

c) target Laser
The target laser is active during measurement depending on the pre-setting. A warning icon (7E) appears in the
display with the laser active. Never look into the laser and measuring apertures (8 and 9) during measurement.
The target laser is designed as a twin device and marks the inner, approximate edge area of the measured area
(approx. 90%).
When both laser points meet, the smallest measuring
area has been reached. It is 18 mm in diameter.
For large distances, the two laser points move apart
according to the measuring area.

8. CommISSIoNINg

Before working with the meter, you have to insert the enclosed battery.
Insert the battery as described in the chapter "Cleaning and Maintenance".
The IR-thermometer permits individual system settings for measuring that you should perform after initial commis-
sioning.
a) System Settings
Briefly push the measuring button (5) to get to the setting mode "SET". The meter
switches on. The lower display area shows the main menu for the three function but-
tons "F1", "F2" and "F3". Use the button "MODE" to switch to the next main menu or
terminate a selected function to return to the main menu.
Push the button "MODE" thrice until the function display "SET" appears.
Push the button "F2" to select the function "SET".
34