General information about radio operation
7
General information about radio
operation
Radio transmission is performed on a non-exclusive trans-
mission path, which means that there is a possibility of
interference occurring. Interference can be caused by e.g.
switching operations, electrical motors or defective electri-
cal devices.
The range of transmission within buildings can
differ greatly from that available in the open air.
Besides the transmitting power and the reception
characteristics of the receiver, environmental
factors such as humidity in the vicinity have an
important role to play, as do on-site structural/
screening conditions.
Hereby, eQ-3 AG declares that this device conforms with
the essential requirements and other relevant regulations
of Directive 1999/5/EC.
The full declaration of conformity is provided under
www.homematic.com.
8
Start-up
8.1
Inserting (replacing) batteries
To insert or replace the batteries, proceed as follows:
• Once mounted, the electronic unit (M) can easily be
pulled out of the frame (L) and removed from the mount-
ing plate (K). To remove the electronic unit from the
frame, take hold of the sides of the electronic unit and
50