Supply Voltage - HBM T40B Montageanleitung

Device plug
6 1
5 7
3
4
Top view
1)
Distribution system for electrical energy with greater physical expansion (over several test
benches, for example) that may possibly also supply consumers with high nominal (rated) cur­
rents.
T40B
Assignment for plug 3 - Supply voltage and voltage
output signal
Plug pin
1
2
3
2
4
5
6
7
Assignment for plug 4
TMC - only for connection to the TIM 40/TIM-EC Torque
Interface Module within HBM.
6.4

Supply voltage

The transducer must be operated with a separated
extra‐low voltage (nominal (rated) supply voltage 18 to
30 V ). You can supply one or more torque flanges
DC
within a test bench at the same time. Should the device
be operated on a DC voltage network
cautions must be taken to discharge excess voltages.
Assignment
Torque measurement signal
(voltage output; 0 V)
Supply voltage 0 V;
Supply voltage 18 V to 30 V DC
Torque measurement signal (voltage output;
±10 V)
Not in use
Shunt signal trigger 5 V to 30 V
Shunt signal 0 V;
Shielding connected to housing ground
A3452-10.0
Electrical connection
1)
, additional pre­
47