Specifications; Plug Configuration - Stageline PMX-122FX Bedienungsanleitung

6 Specifications

GB
Block diagram see page 61
Output power
rms power
at 4 Ω speaker: . . . . 2 × 400 W
at 8 Ω speaker: . . . . 2 × 300 W
bridged operation: . . 1 × 700 W at 8 Ω
Maximum power: . . . . 2 × 600 W at 4 Ω
Inputs
(sensitivity/ impedance; connection)
Mic: . . . . . . . . . . . . . . 0.5 mV/3 kΩ; XLR,
Line (mono channel): . 2 mV/10 kΩ;
Line (stereo channel): 8 mV/10 kΩ;
Tape In: . . . . . . . . . . . 60 mV/8 kΩ; RCA,
Aux Return: . . . . . . . . 80 mV/10 kΩ;
Insert (Return): . . . . . . 80 mV/9 kΩ;
Outputs
(level / impedance; connection)
Main Mix Out, stereo: . 1.5 V (at indication
Mono Out: . . . . . . . . . 500 mV/ 120 Ω;
Tape Out, stereo: . . . . 680 mV/ 1 kΩ; RCA
Aux Sends, mono: . . . 10 V/ 120 Ω;
Headphone impedance: ≥ 8 Ω
Frequency range: . . . . . 20 – 20 000 Hz
THD: . . . . . . . . . . . . . . . < 0.04 %
S/N ratio: . . . . . . . . . . . . 89 dB
Crosstalk: . . . . . . . . . . . -63 dB
Equalizer controls
bass frequencies: . . . . ±15 dB / 80 Hz
high frequencies: . . . . ±15 dB / 12 kHz
mid-frequencies
mono channel: . . . . . . ±15 dB / 100 – 8000 Hz
mid-frequencies
stereo channel: . . . . . ±15 dB / 500 Hz
Equalizer: . . . . . . . . . . . ±15 dB at
Low cut filter: . . . . . . . . . 75 Hz / 18 dB per oct.
Compressor
threshold: . . . . . . . . . .
ratio: . . . . . . . . . . . . . . 2 : 1 to ∞ : 1
attack time: . . . . . . . . 1 ms
release time: . . . . . . . 2 s
Phantom power
for Mic 1 – 12: . . . . . . . . +48 V
Voltage for console light: 12 V /500 mA
Mains voltage: . . . . . . . . 230 V~ / 50 Hz
Power consumption
at no-load operation: . 60 VA
at maximum output
power: . . . . . . . . . . . . 1250 VA
Ambient temperature: . . 0 – 40 °C
Dimensions (W × H × D): 545 × 145 × 465 mm
Weight: . . . . . . . . . . . . . 12.5 kg
18

6.1 Plug configuration

Speaker connections
for stereo operation or 2-channel operation
2-pole 6.3 mm plug
SPEAKON
2+
balanced
2-
6.3 mm jack, bal.
6.3 mm jack, bal.
Speaker connection at jack "A"
for bridged operation
3.5 mm jack, unbal.
SPEAKON
6.3 mm jack, bal.
2+
2-
6.3 mm jack, unbal.
Microphone connections
0 dB) / 120 Ω;
XLR plug for balanced connection
XLR, bal. and
6.3 mm jack, unbal.
6.3 mm jack, unbal.
6.3 mm jack, unbal.
Line signal connections
XLR inline jack for balanced connection
2
3-pole 6.3 mm plug
for balanced connection
2-pole 6.3 mm plug
±15 dB / 3 kHz
for unbalanced connection
63 / 160 / 400 Hz /
1/ 2.5 / 6.3 /16 kHz
6.3 mm stereo plug
for stereo signals (Phones / CTRL-Room)
- 40 dB to +22 dB
3-pole 3.5 mm plug
for stereo signals (Aux In)
3-pole 6.3 mm plug
for jacks INSERT
All rights reserved by MONACOR
manual may be reproduced in any form or by any means for any commercial use.
T = positive pole
S = negative pole
® compatible plug
1+ = positive pole
1-
1- = negative pole
1+
® compatible plug
1+ = positive pole
1-
2+ = negative pole
1+
1 = ground
2 = signal +
-
3 = signal
1 = ground
1
2 = signal +
3
3 = signal -
T = signal +
R = signal -
S = ground
T = signal
S = ground
T = left channel
R = right channel
S = ground
T = left channel
R = right channel
S = ground
T = send (output)
R = return (input)
S = ground
® INTERNATIONAL GmbH & Co. KG. No part of this instruction
Connection for two foot pedals
3-pole 6.3 mm plug
FX1
T R S
T
S
FX 1, FX 2 = momentary pushbuttons for the
effect processors FX 1 and FX 2
Connection for a console light
XLR plug
1 = negative pole 12 V
2 = positive pole 12 V
3 = free
Subject to technical modification.
FX2
R