Adjusting Display Brightness - Yamaha AV-S77 Bedienungsanleitung

The Auto Power Off function may not work properly
depending on the signal output level of the connected
component. In this case, you can refer to the table described
below to change the sensitivity of the Auto Power Off
function.
Pressing + will change the display from top to bottom,
while pressing – will change the display from bottom to top.
Display Setting/Symptom
OFF The Auto power Off function is turned off.
1 The unit enters the Auto Power Off mode even when
the signal is being input.
2 Normally select this position to turn the Auto Power
Off function on.
3 The unit does not enter the Auto Power Off mode
even when no signal is input.
When the setting is completed
After about 10 seconds, the unit returns to the main display
("input name" or "DSP program name" display). Or, press
MENU until the main display appears.

Adjusting Display Brightness

The display brightness of the front speaker unit can be
adjusted as follows.
1
Press MENU to display "Dimmer".
The currently brightness level (such as "Dimmer: ±0")
is displayed.
MENU
2
Press MENU + or – to adjust the brightness.
Pressing + brightens the display, while pressing – dims
the display. Brightness can be adjusted from –3
(dimmest) to +3 (brightest). The brightness of +3
(brightest) is the same as that of the display right after
the AV-S77 is operated.
–
When the setting is completed
After about 10 seconds, the unit returns to the main display
("input name" or "DSP program name" display). Or, press
MENU until the main display appears.
+
Naming the Input Terminals
It is possible to give names to the AUX, DIGITAL 1 and
DIGITAL 2 input terminals. (It is not possible to change the
input names for the TV or VIDEO input terminals.)
If you select a name so that you can easily find out which
component is connected to the terminal, it will be
convenient when you select an input source. For example, if
an MD recorder is connected to the AUX, you can name
that source "MD", or if a DVD player is connected to the
DIGITAL 1 terminal, you can name that source "DVD".
1
Press MENU to display "Input Name".
MENU
2
Press INPUT / and select the input you
h
g
want to name (AUX, DIGITAL 1 or DIGITAL 2).
h
INPUT
g
3
Press + or – to select the name.
–
If you select AUX in step 2 above, names will be
displayed in the following order when you press +.
AUX AUX: VIDEO2
AUX: GAME
AUX: CD
AUX: MD
If you select DIGITAL 1 or 2 in step 2 above, names will
be displayed in the following order when you press +.
DIGITAL 1 D1: DVD
D1:GAME D1: MD
y
• "D1:" is displayed before the name when DIGITAL 1 has been
selected, while "D2:" is displayed before the name when
DIGITAL 2 has been selected.
• Pressing – displays the names in reverse order.
MENU FUNCTIONS
+
AUX: CABLE
AUX: SAT
AUX: LD AUX: DVD
D1: LD
D1: CD D1: SAT
29
E-