Interactions Between Control Heads; Dual Control Head Link; Audio Accessories - Motorola MTM800 FuG Bedienungsanleitung

and Font Level (provided that control heads are different). These menu items are configured separately for each
control head.
Note: If this feature is enabled by your service provider, appropriate icons appear on the display.
Check with your service provider default accessory selections and the radio behavior for all types of calls as each
control head can have different setup.

Interactions between Control Heads

Your service provider can connect to one transceiver either two the same control heads (two Remote Ethernet Control
Heads, or two Telephone Style Control Heads), or two different control heads (one Remote Ethernet Control Head
and one Telephone Style Control Head).
You can use both control heads interchangeably for the same activity (for example, writing a message). If you start an
activity on one control head you can continue it on the second, provided that token is free.
Token is a right to use a key or button for a period of time. If you press a key/button on one control head, token
activates on it, and no one can press anything on the second control head until token time passes. After you release the
key/button, token becomes available again and can be taken over by the second control head. When token is activated,
Key Press Token icon is visible on the display. By default, token time is set to 3 seconds.
Note: Token does not apply to E
control heads at any time.
If control heads are different, when you operate on one control head, the second one displays screen saver.

Dual Control Head Link

Dual Control Head Link is a connection that occurs when both control heads are properly connected to the transceiver
and can communicate.
When the Dual Control Head Link is established, control heads play a tone and display Dual Control Head icon. Full
functionality is available on both devices.
When one control head cannot connect to the transceiver upon power up, the radio displays Single Control Head icon
and enters Single Control Head mode.
When one control head disconnects from the transceiver during operation:
• The active control head displays Link Error icon.
• The inactive control head displays Link Error and shows Link Error display (if power is available).
Turning on/off one control head results in simultaneous turning on/off the second control head.

Audio Accessories

Depending on a call type, voice can be routed to control heads and audio accessories connected to them in different
ways.
During an outogoing group call, voice can be heard either on one control head or on both control heads (depending on
your service provider's settings).
During an incoming group call, voice is always heard on both control heads. However, if two accessories are
connected to one control head (to the front and the rear connector), voice is transferred through only one of them, the
one with higher priority. Priority is following (from the highest): handset (must be off-hook), HSM, external speaker.
Private calls are always transferred to the control head that receives a call.
Only one microphone/PTT can be opened at a time. The microphone that is pressed as first is allowed to initiate the
transmission.
button and O /O
MERGENCY N FF
/ / key. These can be pressed on both
END HOME
| |
Features | 109
Send Feedback