Unpacking And Connecting; Unpacking; Assembly - Dirt Devil Centrino XL Bedienungsanleitung

2 Unpacking and connecting

2.1 Unpacking

2 Unpacking and connecting

2.2 Assembly

2
1
3
Fig.2
1
3
2
Fig.3
1
4
Fig.4
22
1. Unpack the appliance and all accessory parts.
2. Check the contents are all there. Information regarding
the scope of delivery, ZPage 18, "An overview of your
Centrino XL".
ATTENTION:
Always transport/send the appliance in its original pack-
aging so that it does not become damaged. Keep the
packing material for this purpose.
Dispose of any packing material that is no longer
required in accordance with the provisions applicable in
your country.
NOTE:
If you should notice damage due to transport, then con-
tact your dealer immediately.
WARNING:
Only assemble the appliance if the plug has been pulled
out of the socket. It could be switched on by accident.
1. Push the end of the suction hose (Fig. 2/1) into the re-
ceiver point (Fig. 2/2) of the cylinder vacuum cleaner
until the lock audibly clicks into place. Make sure that
the release button (Fig. 2/3) points to the right as illus-
trated.
2. Push the handle (Fig. 3/1) into the upper end of the tel-
4
escopic tube (Fig. 3/2).
3. Push the floor nozzle (Fig. 3/3) onto the lower end of the
telescopic tube (Fig. 3/4).
NOTE:
It may be necessary to push a bit harder.
4. Then push the furniture brush (Fig. 4/2) and the crevice
nozzle (Fig. 4/3) with the upholstery nozzle (Fig. 4/1)
onto the holders.
2
5. Adjust the length of the telescopic tube. To do this, push
the telescopic tube lock (Fig. 4/4) downwards. Then pull
the telescopic tube to the desired length. To lock it, re-
lease the telescopic tube lock when you let go. You will
hear an audible click.
3
Your cylinder vacuum cleaner is now ready to use.