Miller Revolution Handbuch Seite 4

STEPS FOR ENSURING A SNUG FIT
D. Adjusting Cam Buckles
D.1 D.2
D.1 Unclip the web end finial from the webbing.
D.2 Pull webbing downwards to adjust tighter
D.3 Reposition web end finial.
INSTALLING OPTIONAL ACCESSORIES
E. Connecting Accessories
E.1 E.2
E.1 Locate the figure « 8 » shaped composite attachement clip on the back of
the accessory.
E.2 Identify the green button attachement point on the belt or harness that will
be used.
E.3 Place the widest end of the figure « 8 » over the green connection button.
E.4 Push the accessory downward until you feel it snap into place.
E.5 To remove, reverse procedure by gripping 1 loop and pulling upward.
Miller integrated accessories have a weight limit of 11kg, when connected via the
composite link. For loads heavier than 11kg, connecting to a belt via the tunnel loop is
recommanded for more even weight distribution. The combined weight of the harness
user, and all attached tools and accessories should not exceed the maximum
6
capacity of the fall protection system being used.
D.3
E.3 E.4
INSTALLING SHOULDERS PADS
F. Optional Shoulder Pads
Optional harness shoulder pads are available.
Please contact your sales person or Miller customer service for more information.
G. Installing shoulder pads
G.1 G.2
G.4
G.1 Turn the harness, so that the D-ring is laying up on a flat surface.
G.2 Take one of the shoulder pads and place your finger over the Velcro
G.3 Lift up the webbing shoulder strap and carefully slide the Velcro portion of the
shoulder pad into the pocket.
G.4 Remove your finger and press the two Velcro strips together.
G.5 Finish by wrapping the other two sets of Velcro around the shoulder
strap webbing.
F.
G.3
G.5
®
.
7