PeakTech 1295 Bedienungsanleitung Seite 153

(4) Set the network parameters of the oscilloscope. In the oscilloscope, Press
the Utility button, select Config in the left menu. Select Net Config in the
bottom menu. Set the IP Address and Port to the same value as the
"Ports-settings" in the software in step (3). The Netmask and Gateway should
be set according to the router. You can refer to "
(5) " on P50. ouch
T
the software, the connection is successful.
Figure 0-7 Set the network parameters of the oscilloscope
To learn about how to operate the software, you can press F1 in the software to
open the help document.
to complete the setting. If you can get data normally in
152