PeakTech 1295 Bedienungsanleitung Seite 152

Figure 0-5 Set the network parameters of the computer
(3) Set the network parameters of the Software. Run the software on the
computer; choose the "Ports-settings" of the "Communications" menu item.
Set "Connect using" to LAN. About the IP, the first three bytes is same as the
IP in the step (2), the last byte should be different. Here, we set it to
192.168.1.72. The range of the port value is 0～65535, but the port which
under 2000 is always be used, so it is suggested to set it to the value above
2000. Here, we set it to 3000.
Figure 0-6 Set the network parameters of the Software
151