Connecting Elements; Assembly Procedure - Landmann Grill Chef 11768 Montage- Und Betriebsanleitung

Connecting elements

Assembly procedure

CAUTION!
For your own safety the bolt heads should
always point outwards, otherwise there is a
risk of injury.
In order to prevent undesired material tension
only tighten all of the screw connections after
completing assembly.
1. assemble the bottom insert (d) to the legs
(H) by using m6x20 bolts, m6 nuts and Ø6.25
washers.
2. Use m6x20 bolts, Ø6.25 washers and
m6 nuts to fasten the small retaining
ring (G) to the inside of the legs (H).
NOTE: There are three oval holes in the retaining
ring (G) which correspond with the oval holes in
the legs (H).
3. Use m6x20 bolts, Ø6.25 washers and m6 nuts to
secure the grill struts (F) to the small retaining
ring (G) from the inside. Secure the grill struts
(F) to the large retaining ring (E) from the inside
in the same way.
4. Turn the fire basket over and assemble the legs
(H) to the ash plate (I). Insert the m6x12 bolts
through the ash plate (I) and the legs (H) from
underneath and secure the bolts in place by
using m6 cap nuts.
M6x20 M6x12 M6
48x 3x 48x
5.
6.
To prevent the fire bowl from tipping over, it
must be placed on a stable and firm surface
during use.
M6 Ø6,25
3x 48x
Set the fully assembled fire basket with the ash
plate (I) upright.
If you want to use the fire basket as a barbecue,
proceed as follows: secure the handles (C) to the
fixtures on the fire bowl (B) (see illustration).
Suspend the fire bowl (B) with the assembled
handles (C) on the large retaining ring (E) of the
fire basket. Place the cooking grill (a) onto the
large retaining ring (E).
WARNING!
9
GRILLCHEF