Operation - Holzmann MFW 228 Originalbetriebsanleitung

9 OPERATION

To use the different tools, press the shaft lock button, unscrew the chuck change the tool and fít
the chuck again.
Start the grinder with push the ON/OFF switch.
+
By pushing the button speed will be faster by pushing the
Stand (Abb.2): Fix the bench clamp to the bench top (max 60mm) using the retaining screw.
Screw the thread of the telescopic arm into the connecting screw. For vertical attachment
positions the connecting screw can be placed in the hex profile.
TIP: When working with the flexible shaft, always hang the machine on the stand to avoid loss of
speed through excessive flexion.
HOLZMANN MASCHINEN Austria
 Never leave the machine running unattended! Before leaving the
working area switch the machine off and wait until the machine stops.
 Always disconnect the machine prior to any actions performed at the
machine.
 Avoid unintentional starting
 Do not use the machine with damaged switch

 The plug of an electrical tool must strictly correspond to the socket.
Do not use any adapters together with earthed electric tools
 Each time you work with an electrically operated machine, caution is
advised! There is a risk of electric shock, fire, cutting injury;
 Protect the machine from dampness (causing a short circuit)
 Use power tools and machines never in the vicinity of flammable
liquids and gases (danger of explosion)
 Check the cable regularly for damage
 When working with the machine outdoors, use extension cables
suitable for outdoor use
 Do not use the cable to carry the machine or to fix the work piece
 Protect the cable from heat, oil and sharp edges

Avoid body contact with earthed
 Before starting the machine remove any adjusting wrenches and
screwdrivers
 Rotating parts can cause severe cut injuries
 Keep the drills sharp and clean, so they get stuck less often and are
easier to guide
 Keep any machine that is not being used out of reach of children
www.holzmann-maschinen.at
–
button speed will be slower.
Qualitäts-Multifunktionswerkzeug-SET / quality-multitool-SET
OPERATION
Seite 12
MFW 228