Trotec MultiMeasure BASIC BP10 Bedienungsanleitung Seite 27

Increase emissivity
The "Emissivity" symbol (9) flashes.
An arrow (13) is shown.
Press the "Laser" button (5) to increase emissivity.
Decrease emissivity
The "Emissivity" symbol (9) flashes.
An arrow (13) is shown.
Press the "Laser" button (5) to decrease emissivity.
EN
Continuous measurement
The "Continuous measurement on" symbol (18) is
shown.
The "Off" message appears in the display.
Press the "Laser" button (5) to switch on continuous me-
asurement.
The "On" message appears in the display.
In continuous measurement mode, the device stays
running until the "Laser" button (3) is pressed again.
Operating manual - Infrared thermometer BP10
B - 11