Dd.seat Pan; Ee. Removable Seat Pan - Sunrise Medical Quickie IRIS Benutzeranweisungen

E NG LI S H
4) Growable Strut Tube Width Adjustment (Roller assembly)
a. Remove the hardware (G), (H), and (I) from the strut tubes.
b. Adjust all three tubes an equal distance, and re-tighten the hardware to a torque setting
of 150 in-lbs after adjusting the strut tubes.
NOTE– Use a torque setting of 200 in.-lbs. when tightening hardware (J)f
DD. SEAT PAN
51
The seat pan of the IRIS is designed to accommodate depth adjustment.
Depth adjustment
a. Loosen and remove all bolts (A).
b. Adjust the seat pan to the desired depth.
c. Replace and tighten all bolts.
NOTE– Use the holes that place the bolts as far away from each other as possible.
Width adjustment
a. Loosen and remove all bolts (B).
b. Adjust chair to the desired width.
c. Replace and tighten all bolts.

EE. REMOVABLE SEAT PAN

I. Removing and Attaching the Seat Pan
To remove, pull out release pins (C) loosen the two knobs (D) on the underside of the seat pan,
a)
grasp front and rear of seat pan and firmly pull upward until seat mounting clips disengage from the
frame.
To reattach, position seat pan on frame rail so that the front bracket mounting grooves slide into the
b)
knobs on both sides of the frame. Position the rear mounting clips on the frame and push down
firmly on seat pan. Be sure to engage all four mounting points on frame rails. Tighten knobs and
reinsert release pins.
Check for engagement by pulling up lightly on seat pan. It should not move upward. Failure to
check for engagement may lead to injury if the seat mounting clips are not fully seated.
2. Adjusting Seat Pan Width
Remove the hardware (F) that secure each seat mounting clip (G) to the seat pan.
a)
Position the seat mounting clips to the desired position, reattach the screws. Each hole is
b)
1/2" apart.
NOTE- Tighten screws to I00 in.lbs. torque.
c) Repeat steps "a" and "b" for each mounting clip.
NOTE- Both sides must be mounted to same hole position.
3. Adjusting Seat Pan Depth
Loosen the two lock nuts (H) on underside of seat pan that attach the front seat
a)
pan panel to rear seat pan panel.
Reposition seat pan to the desired depth, and reattach the lock nuts.
b)
NOTE- Tighten lock nuts to I00 in. lbs. torque.
52
53 54
WARNING
IX. DEALER SERVICE & ADJUSTMENT
50
31
G
H
50
I
J
51
52
53
54
MK-100151 Rev. D