Seat To Back Angle Adjustment; Vanity Flap Adjustment - Sunrise Medical Jay J2 Plus Back Gebrauchsanweisung

6
4. Install the both left and right retaining pins into
the 12-degree position(F) through the side-
plate(E), upper connector(A) and into the back
shell receiver(D) Figure 7.
5. Adjust back shell to be centered between side
plates (G)
6. Tighten both upper connector fasteners (H) while
gently holding the upper connector inward
towards the center of the chair.
7. Tighten both lower connector fasteners (I).
8. Back shell should rotate freely on pins and be
easily removable.
NOTE– Important: Ensure that the back shell rotates freely
and that the upper connectors do not hit the side
plates. If required, adjust the side plate angle to
achieve smooth operation.
H
I
G
XT200005 Rev. B
I n s t a l l a t i o n
+2
0
2 4
+3 +1
1 3
Figure 8
H
I
Figure 10
Figure 9
I n s t a l l a t i o n

SEAT TO BACK ANGLE ADJUSTMENT

F (See Figure 11)
Tools: 3/16 Allen wrench
6 8
10
1. Remove the retaining pin (A) on each side plate.
12
5 7
9
11
2. Loosen the two fasteners (B) that hold the back
shell receiver for both sides.
3. Rotate the back shell and right back shell receiv-
er to the desired angle (C) and install retaining
pin (A) through the right side plate, upper con-
nector and back shell receiver. Repeat the
process for the left side.
4. Tighten both fasteners (B) to secure the back
shell receiver on each side

VANITY FLAP ADJUSTMENT:

Tools: 5/32 Allen Wrench
1. Loosen the button head cap screw (A) on both
hinges to allow rotation of the vanity flap.
2. Rotate the vanity flap into the desired position.
3. Tighten both button head cap screws (A) to
secure the vanity flap in position.
7
B
A
Figure 11
+2
0
2 4
C 6 8
10
12
+3 +1
1 3
5 7
9
11
Figure 12 Angle Positions
A
Figure 13
XT200005 Rev. B